Skip to content

Category: Tech

3D Printing – 3D Touch

You want to add Automatic Bed Levelling to your 3D Printer? This article covers the basics of installing the hardware and compiling updated firmware and installing it to your printer.

3D Printing – Slicing Software and Tools

If you're new to 3D Printing then you need to know some of the Slicer tools available to you that help bring your prototypes and creations to life. I cover some of the tools I use which may be useful to you as you start your journey.

3D Printing – Bed and Adhesion

Bed Adhesion is one of the key issues with 3D Printing, in this article I look at some of the options and tricks you can use to help your prints stay when it matters most.

Headless Raspberry Pi Desktop Installation

This article explains how to install and configure a Raspberry Pi with Debian OS without the need to plug your Pi into an external Keyboard, Mouse and Monitor. As an optional extra, I'll show you how to enable VNC if you want to remotely connect to the Pi desktop.

Where’s Lou?

Hello, the following is a true story which started life as a simple man mistake, I’d left the empty loo roll on top of the toilet of my bubble support […]

1.21 Gigawatts

My home wired network developed a faulty LAN port, and I didn't really want to pull new cable through the house. Thankfully with the Preciva Network Repair Tool Kit, Identifying the fault and fixing it, turned out to be much easier with the upgraded Network Testing Tool.

Upgrading your Pi-Hole

In today's article, I'll show you the simple steps needed to update and upgrade your PiHole installation.